5-81container Commands/wait{=boolean}Specifies whether the command performs the arrayreconfiguration operation synchronously or asynchronously. Ifyou set this switch to TRUE, the command performs the arrayreconfiguration operation synchronously, which means thecommand prompt does not return until the arrayreconfiguration operation completes. If you set this switch toFALSE, the command performs the array reconfigurationoperation asynchronously, which means the command promptreturns immediately.ExamplesUse the container list command to obtain information aboutany existing arrays. As the following example shows, there is anarray 0 (a mirror set) and an array 1 (a volume set) on this controller:AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------0 Mirror 15.0MB None 1:02:0 64.0KB: 15.0MBTigris 1:03:0 64.0KB: 15.0MBE: 1 Volume 15.0MB NTFS 1:00:0 64.0KB: 15.0MBThe following example reconfigures a volume set to a stripe set:AAC0>container reconfigure /partition_size=1 /stripe 1Executing: container reconfigure /partition_size=1 /stripe=TRUE 1As the command executes, note that the title bar of the DOS windowdisplays the status of the command. For example:Stat:OK!Task:100,Func:RCF Ctr:1,State:RUN 97.2%See page 3-10 for detailed information on the status information thatthe command displays in the title bar as it executes the task.
