5-84container Commandscontainer remove drive_letterTo remove a drive letter, use the container removedrive_letter command. To use the container removedrive_letter command, none of the array’s files can be open.Command AvailabilityThis command and its associated switches (if any) are supported onthe following operating systems: Windows NT Windows 2000 (basic disk only) Windows XP (basic disk only)Syntaxcontainer remove drive_letter {string}Parameters{string}Specifies the drive letter to remove. The colon (:) after the driveletter is optional.ExamplesBefore removing a drive letter from an array, use the containerlist command to obtain information about any existing arrays. Asthe following example shows, there is an array 0 (a volume set) onthis controller with a drive letter F:AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MBThe following example removes drive letter F from array 0:AAC0> container remove drive_letter FExecuting: container remove drive_letter “F”
