5-16container CommandsExamplesBefore creating a multilevel stripe set, use the container listcommand to obtain information about any existing arrays.As the following example shows, there are two existing arrays(mirror sets) on this controller at the time the multilevel stripe set iscreated. These mirror sets were previously created with thecontainer create mirror command.AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------0 Mirror 15MB None 0:02:0 64.0KB: 15.0MB0:02:0 15.0MB: 15.0MB1 Mirror 15MB None 0:03:0 64.0KB: 15.0MB0:03:0 15.0MB: 15.0MBThe following example shows how to create a multilevel stripe setfrom two equally sized arrays, using the default stripe size of 64 KB.In this example, the two equally sized arrays are mirror sets:AAC0>container create mstripe 0 1Executing: container create mstripe 0 1container 0 createdOn UNIX systems, the message displayed after you execute thecontainer create mstripe command includes the root specialfile associated with the newly created multilevel stripe set.Use the container list command after using the containercreate mstripe command to display information about themultilevel stripe set, as in the following example:AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------0 Stripe 30MB 0 64KB None63 Mirror 15MB 0:02:0 64.0KB: 15.0MB0:02:0 15.0MB: 15.0MB62 Mirror 15MB 0:03:0 64.0KB: 15.0MB0:03:0 15.0MB: 15.0MB
