6-6controller Commandscontroller firmware compareTo compare the contents of each of the flash components on acontroller to the corresponding image in a pair of user flash image(UFI) files and indicate whether they match, use the controllerfirmware compare command.Syntaxcontroller firmware compare[/C[{controller_ID}][{controller_ID}...][/D{UFI_file_path}]Switches/C{controller_ID}Specifies the controller ID representing the set of controllers onwhich to perform the firmware comparison.If you do not specify this switch, this command compares theflash components on controller 0./D{UFI_file_path}Specifies the path where the pair of UFI files are located.If you do not specify this switch, this command compares theflash components against the pair of UFI files in the currentdefault drive and directory.ExamplesThe following example compares the contents of a controller’s flashcomponents to the corresponding image in a pair of UFI files.AAC0> controller firmware compare D:\Executing: controller firmware compare “D:\”The controller’s firmware matches the firmware in the specified flashimage files.Related Information:controller commands: controller firmware save (page 6-7) controller firmware update (page 6-9)
