5-20container Commands{container}...Specifies the ID (0 to 63) of one or more additional arrays fromwhich you want to create the multilevel volume set. You canuse up to 16 arrays. Typically, the additional arrays you specifyare the same type as the first array. For example, if the firstarray is a stripe set then any subsequent arrays are also stripesets.Switches/label{=string}Specifies a label to be assigned to the newly created multilevelvolume set. You can specify a maximum of sixteen charactersfor the label.If you do not specify the switch, it defaults to no label. If youdo not specify a label, you can do so later by using thecontainer set label command.ExamplesBefore creating a multilevel volume set, use the container listcommand to obtain information about any existing arrays.As the following example shows, there are two existing arrays(stripe sets) on this controller at the time the multilevel volume set iscreated:AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------0 Stripe 45MB 64KB None 0:02:0 64.0KB: 15.0MB0:03:0 64.0KB: 15.0MB0:04:0 64.0KB: 15.0MB1 Stripe 15MB 64KB None 0:05:0 64.0KB: 15.0MB
