5-4container CommandsUse the container list command after using the containeradd_level command to display information about the multilevelvolume set, as in the following example:AAC0>container listExecuting: container listNum Total Oth Stripe Scsi PartitionDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------0 Volume 45MB None63 Stripe 45MB 32KB 0:02:0 64.0KB: 15.0MB0:03:0 64.0KB: 15.0MB0:04:0 64.0KB: 15.0MBThe following list describes the change to the display as a result ofcreating a multilevel volume set with the container add_levelcommand: The Num Label column displays two ID numbers. The first ID(0) is the newly created volume set. The second ID (63) is theoriginal array (the stripe set).If you specified a label when creating the multilevel volumeset, it appears in this column. Because no label was specifiedwhen the multilevel volume set was created, no label appearsin the column. The Type column displays two array types: Volume and Stripe.The Volume array type indicates that the newly created array isa volume set. This is the array created after the containeradd_level command completes.The Stripe array type indicates the array whose ID wasspecified to the container add_level command. This isthe original array previously created with the containercreate stripe command.Related Informationcontainer commands: container extend mvolume (page 5-46) container list (page 5-54) container promote (page 5-69)
