6-19controller CommandsSpecifies whether to turn on or off automatic failover on thespecified controller. You must set this switch to TRUE if youwant to turn on automatic failover on the specified controller.To turn off automatic failover on the specified controller, setthis switch to FALSE. The command defaults to TRUE, whichmeans the command turns on automatic failover on thespecified controller.ExamplesBefore turning the automatic failover feature on or off, check itsstatus by using the controller show automatic_failovercommand.The following example shows that the controller’s automaticfailover is currently off (disabled):AAC0> controller show automatic_failoverExecuting: controller show automatic_failoverAutomatic failover DISABLEDThe following example turns on (enables) the automatic failoverfeature for the currently opened controller:AAC0> controller set automatic_failover /failover_enabledExecuting: controller set automatic_failover /failover_enabled=TRUEThe controller show automatic_failover commandindicates that the controller’s automatic failover is currently on(enabled):AAC0> controller show automatic_failoverExecuting: controller show automatic_failoverAutomatic failover ENABLEDRelated Informationarray commands: array set failover (page 5-100) array set global_failover (page 5-102)controller commands: controller show automatic_failover (page 6-22)
