NetWareUNIX WindowsOS/2MacintoshAXIS 1620 User’s Manual Section 3: Basic Installation 29UsingAXIS IP InstallerFollow the instructions below to set the IP address of your AXIS 1620using the AXIS IP Installer:Important! ❏ You should not use AXIS IP Installer to set the IP address of theAXIS 1620, if you have an active DHCP server in your network.1. Download the AXIS IP Installer to your host. The software isavailable on the AXIS Online CD and on the Axis home page athttp://www.axis.com/.2. Connect the AXIS 1620 to the network. Note the serial numberthat is located on the underside label of the AXIS 1620. You willneed it in the proceedings steps.3. Start the AXIS IP Installer.4. Click the serial number of your AXIS 1620 that appears in theserver list.5. Enter the desired IP address in the designated IP address field andclick the Set IP address button.6. The IP setting process will take approximately 10 to 40 seconds.Click OK in the confirmation box that appears when the IPaddress has been set.Notes: ❏ AXIS IP Installer uses the BOOTP and DHCP protocols tocommunicate with the AXIS 1620. Make sure that at least one ofthese protocols is enabled in your print server.❏ Restart your AXIS 1620, if it does not show up in the server list.
