WindowsAXIS 1620 User’s Manual Section 5: Setting Up - Windows 63Using the MicrosoftLPD monitor withWindow NT 3.5xThis section describes how to set up a Windows NT Serverv3.5 and v3.51 for LPD printing over the TCP/IP protocol, using thebuilt-in Microsoft LPD monitor.Basic Setup If you have not already done so, you should perform the TCP/IP basicsetup procedures prior to installing a printer for LPD printing. Theseprocedures are defined in Assigning an IP address, on page 26 andonwards.Install the TCP/IPProtocol StackIn the Control Panel, click the Network icon. If the TCP/IP Printingentry appears, then TCP/IP is already installed. Close the Networkfolder and continue with Installing a printer on the next page.Follow these steps to install the TCP/IP protocol stack:1. In the Control Panel, select Network.2. Click Add Software...3. Select “TCP/IP Protocol and related components” and thenclick Continue.4. Check “TCP/IP Network Printing Support” and then clickContinue.5. Select path and then click Continue.6. Click OK in the Network Settings dialog box.
