Managing the Hub2-31The SmartSwitch 2000 Chassis Viewduplex mode and negotiation parameters; for Fast Ethernet and Gigabit Ethernetports on second generation devices you can set speed, duplex mode, and flowcontrol parameters; and for COM ports, you can select the operation you wish theport to perform, and set any associated speed parameters. FDDI, Ethernet, FastEthernet, and Gigabit Ethernet Port Configuration windows are available fromthe Chassis View Port menus (except on Ethernet MicroLAN Switches where theyare available from the Bridge Port menu); the COM Port option is available fromthe Device menu.Configuring Standard Ethernet and FDDI PortsThe Port Configuration window available for both standard Ethernet and FDDIports allows you to set an interface to either Standard or Full Duplex Mode. FullDuplex mode effectively doubles the available wire speed by allowing theinterface to both receive and transmit simultaneously. This window will alsodisplay the mode currently in effect on the selected interface.To access the Port Configuration Window:1. From the Chassis View, click to select the port you wish to configure; the PortMenu will display.2. Click on Configuration. The Port Configuration window, Figure 2-14, willappear.To access the Port Configuration window on SmartSwitch 2000 EthernetMicroLAN Switches:1. From the Chassis View, click on Device in the menu bar to access the Devicemenu.2. Click on Bridge Status. In the resulting window click on the Bridge Portbutton (e.g., ) to access the Bridge Port menu.3. Click on Configuration. The Port Configuration window, Figure 2-14, willappear.Figure 2-14. The Port Configuration Window
