If you would like the stored driving positions to berecalled when unlocking your vehicle with the remotekeyless entry transmitter or when you place thekey in the ignition, seeDIC Vehicle Personalizationon page 3-74.To stop recall movement of the memory feature at anytime, press one of the power seat or mirror controls.Two personalized exit positions can also be programmed.Use the following steps to program exit positions:1. Press memory seat button 1 or the button withthe unlock symbol on the remote keyless entrytransmitter with the number 1 on the back torecall the driving position.2. Adjust the driver’s seat to the desired exit position.3. Press and hold the exit button located abovebuttons 1 and 2 on the driver’s door armrestfor at least three seconds.Two beeps will sound to confirm that the exitposition has been saved.4. Repeat the procedure for a second driver usingmemory seat button 2 or the remote keylessentry transmitter with the number 2 on the back.To recall the stored exit positions, press and releasethe exit button. One beep will sound, and the seatwill move to the previously stored exit position for thecurrently identified driver. If an exit position has not beenstored for this driver, the seat will move all the wayback. The position of the outside mirrors is not stored orrecalled for the exit position.If your vehicle has an automatic transmission, thevehicle must be in PARK (P) to recall the exit positions.For a manual transmission, the parking brake mustbe set to recall the stored exit positions.Three chimes will sound and the exit setting will not berecalled if you press the exit button when the vehicleis not in PARK (P) on an automatic transmission or theparking brake is not set on a manual transmission.If you would like your stored exit position to be recalledwhen unlocking the vehicle with the remote keylessentry transmitter or when the ignition is turned off andthe driver’s door is opened, seeDIC VehiclePersonalization on page 3-74.2-55
