Erasing Set Speed MemoryThe set speed memory is erased when the AdaptiveCruise Control switch or the ignition is turned off.Other MessagesThere are three messages that may appear on the DIC.They are SERVICE RADAR CRUISE, CRUISE NOTREADY and CLEAN RADAR CRUISE. These messageswill only appear to indicate a problem with the AdaptiveCruise Control. See DIC Warnings and Messageson page 3-63 for more information.You may also see CRUISE SPEED LIMITED displayedin the HUD. See Head-Up Display (HUD) on page 3-33for more information.Cleaning the SystemThe radar can become blocked by snow, ice, or dirt.If so, you may need to turn off the engine and clean thelens, located on the driver’s side of the front fascia.Clean the surface with a 50/50 mixture of isopropylalcohol and water on a dampened cloth. After cleaningthe fascia lens, try to engage Adaptive Cruise Control.If this does not fix the problem, you may have to removethe fascia lens and clean the inside of the fascia lensand radar lens.To clean the inside of the fascia lens and radar lens,insert a tool into one of the small slots on the inboardside of the lens and pop the lens out. Clean the surfacewith a 50/50 mixture of isopropyl alcohol and wateron a dampened cloth. After cleaning the lens, set thelens back in place and press until it snaps in place.3-27
