The Canadian immobilizer standard requires Canadianowners to see their dealer/retailer for matching newtransmitters when two recognized transmitters are notavailable. United States owners are permitted to match anew transmitter to their vehicle when a recognizedtransmitter is not available. The procedure will requirethree ten minute cycles to complete the matchingprocess. Do the following:1. The vehicle must be off.2. Place the new, unrecognized transmitter in theglove box transmitter pocket with the buttonsfacing to the right.3. Go to the rear of the vehicle and insert the vehiclekey into the key cylinder located on the lowerrear fascia on the driver’s side of the vehicle.See Trunk on page 2-13 for more information onthe key cylinder.4. Open the trunk.5. Turn the key five times within five seconds.6. The DIC message will display OFF-ACC TO LEARN.7. Press the Acc. button.8. The DIC will read WAIT 10 MINUTES and willcount down to zero, one minute at a time.9. The DIC will display OFF-ACC TO LEARN again.10. Press the Acc. button.11. The DIC will read WAIT 10 MINUTES and willcount down to zero, one minute at a time.12. The DIC will display OFF-ACC TO LEARN again.13. Press the Acc. button.14. The DIC will read WAIT 10 MINUTES and willcount down to zero, one minute at a time.15. A beep will sound and the DIC will read READYFOR FOB #1. At this time, all previously knowntransmitters have been erased.16. Once the transmitter is recognized andprogrammed, a beep will sound and the DIC willdisplay READY FOR FOB #2.2-8
