Black plate (59,1)Cadillac CTS/CTS-V Owner Manual (Include Mex) - 2012Instruments and Controls 5-59Canadian radio-frequency lawsrequire transmitter signals to timeout or quit after several seconds oftransmission. This may not belong enough for Universal HomeRemote to pick up the signal duringprogramming. Similarly, some U.S.gate operators are manufactured totime out in the same manner.If you live in Canada, or you arehaving difficulty programming a gateoperator or garage door openerby using the “Programming theUniversal Home Remote System”procedures, regardless of whereyou live, replace Step 3 under“Programming the Universal HomeRemote System” with the following:Continue to press and hold theUniversal Home Remote buttonwhile you press and releaseevery two seconds (cycle) thehand-held transmitter button untilthe frequency signal has beensuccessfully accepted by theUniversal Home Remote. TheUniversal Home Remote indicatorlight will flash slowly at first and thenrapidly. Proceed with Step 4 under“Programming the Universal HomeRemote System” to complete thetraining procedure.Universal Remote SystemOperationUsing Universal RemotePress and hold the appropriateUniversal Remote button for at leasthalf of a second. The indicator lightwill come on while the signal isbeing transmitted.Erasing Universal RemoteButtonsAll programmed buttons should beerased when the vehicle is sold orthe lease ends.To erase all programmed buttons onthe Universal Remote device:1. Press and hold down thetwo outside buttons until theindicator light begins to flash,after 20 seconds.2. Release both buttons.
