4-52 Instruments and ControlsIf you live in Canada, or you arehaving difficulty programming a gateoperator or garage door opener byusing the “Programming UniversalHome Remote” procedures,regardless of where you live,replace Step 2 under “ProgrammingUniversal Home Remote” with thefollowing:2. Continue to press and hold theUniversal Home Remote buttonwhile you press and release everytwo seconds (cycle) the hand-heldtransmitter button until thefrequency signal has beensuccessfully accepted by theUniversal Home Remote. TheUniversal Home Remote indicatorlight will flash slowly at first and thenrapidly. Proceed with Step 3 under“Programming Universal HomeRemote” to complete.Universal Remote SystemOperationUsing Universal Home RemotePress and hold the appropriateUniversal Home Remote buttonfor at least half of a second. Theindicator light will come on whilethe signal is being transmitted.Erasing Universal HomeRemote ButtonsAll programmed buttons should beerased when the vehicle is sold orthe lease ends.To erase all programmed buttons onthe Universal Home Remote device:1. Press and hold down thetwo outside buttons until theindicator light begins to flash,after 10 seconds.2. Release both buttons.Reprogramming a SingleUniversal Home RemoteButtonTo reprogram any of the threeUniversal Home Remote buttons:1. Press and hold the desiredUniversal Home Remote button.Do not release the button.2. The indicator light will begin toflash after 20 seconds. Withoutreleasing the button, proceedwith Step 1 of the section“Programming Universal HomeRemote”.If you have questions or needhelp programming the UniversalHome Remote System,call 1‐800‐355‐3515 or go towww.homelink.com. You may alsocall the customer assistance phonenumber under Customer AssistanceOffices on page 12‑3.