Chapter 33-443.1.20.7 Removing the NCUCase 0006-37621) Remove the three screws [1]; then, pull the upperportion of the NCU case [2] toward you, and liftingit upward, remove the NUC case.F-3-1893.1.20.8 Removing the ScannerUnit 0006-37631) Remove the screw [1] and remove the connector [2]as well as the flat cable [3] on the DCNT board.Remove the tape holding the cable in advance.Prepare a new tape (Part No: AZ7-0008) of a suitablelength before you attach the cable again.F-3-1902) Remove the two front screws [1].F-3-1913) Remove the two screws on the back [1]. Slide thescanner unit [2] to the back; then, remove it bylifting it.F-3-1923.1.20.9 Removing the BoardUnit 0006-37651) Remove the four screws [1] on the back side of thescanner unit. Ensure that the mounting plate [2]does not get lost.F-3-193[1][2][2] [1][3][1][2][1][1][2]
