Chapter 33-542) Remove the front screw [1] and then remove theclaw [2].3) Slightly lift up the left side of the unit and removethe cover as if you were opening the bottom side ofthe left cover [3].F-3-2333.2.3.6 Removing the NCUBoard 0006-36471) Remove the two connectors [1] and the flat cable[2].2) Remove the two screws [3] and remove the NCUboard [4].F-3-2343.2.3.7 Removing the NCUCase 0006-36411) Remove the three screws [1]; then, pull the upperportion of the NCU case [2] toward you, and liftingit upward, remove the NUC case.F-3-2353.2.3.8 Removing the ScannerUnit 0006-36431) Remove the screw [1] and remove the connector [2]as well as the flat cable [3] on the DCNT board.Remove the tape holding the cable in advance.Prepare a new tape (Part No: AZ7-0008) of a suitablelength before you attach the cable again.F-3-236[1][3][2][1][2][4][3][1][2][2] [1][3]
