Chapter 33-593.2.4.8 Removing the ScannerUnit 0006-36441) Remove the screw [1] and remove the connector [2]as well as the flat cable [3] on the DCNT board.Remove the tape holding the cable in advance.Prepare a new tape (Part No: AZ7-0008) of a suitablelength before you attach the cable again.F-3-2542) Remove the two front screws [1].F-3-2553) Remove the two screws on the back [1]. Slide thescanner unit [2] to the back; then, remove it bylifting it.F-3-2563.2.4.9 Removing the BoardUnit 0006-36561) Remove the four screws [1] on the back side of thescanner unit. Ensure that the mounting plate [2]does not get lost.F-3-2572) Open up the board unit [1] and take off theconnector at six spots (five if the unit is notequipped with the fax function) [2] and three flatcables [3].F-3-258[2] [1][3][1][2][1][1][2][1][2][2][3]
