Chapter 33-513.2.2.6 Removing the NCUBoard 0006-36481) Remove the two connectors [1] and the flat cable[2].2) Remove the two screws [3] and remove the NCUboard [4].F-3-2193.2.2.7 Removing the NCUCase 0006-36401) Remove the three screws [1]; then, pull the upperportion of the NCU case [2] toward you, and liftingit upward, remove the NUC case.F-3-2203.2.2.8 Removing the ScannerUnit 0006-36421) Remove the screw [1] and remove the connector [2]as well as the flat cable [3] on the DCNT board.Remove the tape holding the cable in advance.Prepare a new tape (Part No: AZ7-0008) of a suitablelength before you attach the cable again.F-3-2212) Remove the two front screws [1].F-3-2223) Remove the two screws on the back [1]. Slide thescanner unit [2] to the back; then, remove it bylifting it.F-3-223[1][2][4][3][1][2][2] [1][3][1][2][1]
