Chapter 33-813.5.4.9 Removing the NCUCase 0006-36761) Remove the three screws [1]; then, pull the upperportion of the NCU case [2] toward you, and liftingit upward, remove the NUC case.F-3-3473.5.4.10 Removing the ScannerUnit 0006-36781) Remove the screw [1] and remove the connector [2]as well as the flat cable [3] on the DCNT board.Remove the tape holding the cable in advance.Prepare a new tape (Part No: AZ7-0008) of a suitablelength before you attach the cable again.F-3-3482) Remove the two front screws [1].F-3-3493) Remove the two screws on the back [1]. Slide thescanner unit [2] to the back; then, remove it bylifting it.F-3-3503.5.4.11 Removing the TopCover 0006-36801) Remove the two screws [1].2) Remove the connector [2] of the DCNT board.3) Remove the two claws [3] and remove the top cover[4].F-3-351[1][2][2] [1][3][1][2][1][1][2][4][3]
