Chapter 55-415.6.3.2.3 Details of Bit 1 0006-5832It is possible to select the detection time for caarrier disconnection between the DCS signal and TCF signal duringreception.This bit is available for use when #1 SSSW SW18 Bit0 is set to "1".If the symptom is not resolved by setting SW18 Bit 0 to "1," set this bit to "1."5.6.4 Numeric Parameter Settings (NUMERIC Param.)5.6.4.1 #NUMERIC Param. 0006-5833T-5-12No.010Use it to set the length of time for line connection identification.If an error occurs often because of the line condition at time of a communication, increase the parameter.MemoThe line connection recognition time means the period from transmission of dial signal to detection ofsignificant signal for the transmission end, and the period from transmission of DIS signal to detection ofsignificant signal for the receiving end.No.011Set the T1 timer for the receiver (wait time after DIS transmission starts until a significant signal is received).If frequent errors occur during reception because of line connection conditions, increase the value of thisparameter.No.013Set the maximum receivable time per line of image data when receiving image data. If the other party is acomputer fax and the like, and the image data reception time per line is longer, increase the value of thisparameter to lengthen the maximum receivable time.No. Function Selecting range Defaultsetting010 Line connection identification time length 0 to 9999 (10ms) 5500011 T.30 T1 timer (for reception) 0 to 9999 (10ms) 3500013 Maximum time to receive one line of imagedata500 to 3000 (10ms) 1300
