Canon TA-30 Online Manual

Also see for imagePROGRAF TA-30: Quick guide Setup guide

6. After paper feeding has started, do the following operations based on the Manageremaining roll amount setting and the barcode printed on the roll paper (see "KeepingTrack of the Amount of Roll Paper Left").• When selecting Disable or Warning message only in Manage remaining roll amount.A menu for selecting the media type appears on the operation panel. Operate the operation paneland select the media type to be used.• When selecting Barcodes in Manage remaining roll amount and if the barcode is printed.The type and amount of paper left is automatically detected based on the barcode printed on theroll. There is no need to specify the type and length of the paper.• When selecting Barcodes in Manage remaining roll amount and if the barcode is notprinted.A menu for selection of the media type and length is shown on the operation panel. Operate theoperation panel, select the media type to be used, and enter its length.Important• When selecting Enable in Keep media type, there is no need to specify the type of the paper.• Cut the edge of the roll using the Cut paper function if the edge is creased or soiled. (See"Specifying the Cutting Method for Rolls.")• When selecting the media type on the operation panel, make sure the media type set in the printerdriver and the media type loaded on the printer match.Note• For details on media types that you can select, see "Paper Information List."• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissorsor the blade after removing creased edges. (See "Specifying the Cutting Method for Rolls.")• Adjusting the printhead alignment with the type of paper to be used in printing may enhanceprinting quality. (See "Automatic Adjustment to Straighten Lines and Colors.")60