Canon TA-30 Online Manual

Also see for imagePROGRAF TA-30: Quick guide Setup guide

• Paper cutting (to have the roll cut at your specified position)Select this when you want to cut the roll paper by operating the cutter blade using the operation panelafter printing with No or Print Cut Guideline selected in Automatic Cutting in the printer driver.Otherwise choose this option if you want to cut the roll edge after loading a roll.◦ Printer SettingTap paper settings display area >Feed/cut>Cut paper>Yes◦ Driver SettingAutomatic Cutting>No, Yes, Print Cut GuidelineSee "Cutting Roll Paper after Printing" (Windows).See "Cutting Roll Paper after Printing" (macOS).Note• Automatic and Eject are valid only when you have selected Automatic Cutting>Yes in the printerdriver.• With Eject, printing does not resume after a series of jobs have been printed continuously until the roll iscut.• Eject cut or User cut is the preset selection in Cutting mode for some types of paper. For this paper,we recommend keeping the preset cutting mode.• If documents printed using Automatic, Eject, or manual cutting are short, rolls are advanced a specificamount before cutting to prevent problems with cutting and paper ejection. This may create a widerbottom margin, in some cases.Cut rolls manually in the following cases:Eject (when the paper surface is being scratched / to wait for ink to dry)Important• When cutting wide printed documents after ejection, have two people support the documents. If thepaper drops, printed documents may be damaged.• Do not lift the paper when holding printed documents before cutting. If the paper rises, it may affectthe printing quality or cause rough cut edges.Note• Once the following step has been performed, the procedure can be started from step 7 the next time.• Printing the second and subsequent times• Printing after replacing with the same type of paper1. Tap paper settings display area on Home screen of operation panel.81