Canon VB-H43 Operation Manual

Also see for VB-H43: Operation guide Installation guide

Contents

62H.264(1)Configure settings using H.264(1) when using H.264video for upload or memory card recording. H.264(2)video cannot be used for upload or memory cardrecording.H.264(1) video can be displayed using Admin Viewer andRM-Lite Viewer. It cannot be displayed using VB Viewer.(1) [Video Size]Select the size of the transmitted video. The videosizes that can be selected depend on the [Video SizeSet] setting.(2) [Bit Rate Control]Select [Do not use bit rate control] or [Use bit ratecontrol].Select [Use bit rate control] when [Video Format]under [Upload] is set to [H.264(1)] or when [VideoFormat] under [Memory Card] is set to [H.264(1)].(3) [Target Bit Rate (kbps)]If [Use bit rate control] is selected in (2), select adesired target bit rate from the 17 levels from [64] to[16384].(4) [Video Quality]If [Do not use bit rate control] is selected in (2), selecta desired quality from 1 to 5 (total 5 levels) for H.264video transmission.Greater values have higher quality.(5) [Frame Rate (fps)]Select [30], [15], [10], [6], [5], [3], [2] or [1] (fps) forthe frame rate of video transmitted.(6) [I Frame Interval (sec)]Select [0.5], [1], [1.5], [2], [3], [4] or [5] for the I frameinterval (sec) for H.264 video.H.264(2)(1) [H.264(2)]Select [Enable] to distribute H.264 video using twostreams.H.264(2) video can be displayed using Admin Viewerand RM-Lite Viewer. It cannot be used for upload,memory card recording, or by VB Viewer.Refer to the settings for “H.264(1)” for details about[Video Size], [Bit Rate Control], [Target Bit Rate(kbps)], [Video Quality], [Frame Rate (fps)], and [IFrame Interval (sec)] settings.On-screen displayImportant• When streaming two H.264 videos, setting the video sizesettings for H.264(1) and H.264(2) to the followingcombinations restricts the frame rate to a maximum of 15 fps.For all other combinations, a frame rate of up to 30 fps canbe selected.• When [H.264(1)] is selected for the memory card recordingand upload settings, the following restrictions apply to the[H.264(1)] setting.- Only [Use bit rate control] can be selected for [Bit RateControl].- Only [3072] or less can be selected for [Target Bit Rate(kbps)].- Only one of [0.5], [1], and [1.5] can be selected for [IFrame Interval (sec)].• Network load will increase if a larger video size is set orhigher video quality and target bit rate are set, as thisincreases data size per frame. As a result, the following couldoccur:JPEG: The frame rate may dropH.264: Video may be temporarily disrupted• Block noise may become noticeable if a large video size andlow target bit rate are set.• The data size may increase depending on the type ormovement of the subject. If the frame rate remains low orother undesirable conditions continue for a prolongedperiod, lower the video size or quality setting.• The included RM-Lite cannot record H.264 video.• H.264 video can be displayed using Admin Viewer and RM-Lite Viewer. H.264 video cannot be displayed using VBViewer.H.264(1) H.264(2)1920 x 1080 All sizesAll sizes 1920 x 10801280 x 960 1280 x 9601280 x 720 1280 X 720