| 
1234567891011Back NextPreviousTOP6-10Before Using theMachineDocument and PaperCopyingSending and Receiving (MF6595cx/MF6595/MF6590 Only)Printing andScanningNetwork (MF6595cx/MF6595/MF6590/MF6540 Only)Remote UI (MF6595cx/MF6595/MF6590/MF6540 Only)System SettingsMaintenanceTroubleshootingAppendixIndexTable of ContentsSetting Up a Computer for Printing/Sending a FaxThis section describes procedures for Setting Up a computer forprinting/sending a fax.Before setting up a computer for printing/sending a fax, it isnecessary to perform the following setup procedures.It is recommended that the network administrator perform the followingprocedures.1. Network Cable Connection (See “SoftwareSettings with Computer,” in the Starter Guide.)Connect the machine to your network using the network cables.2. Preparation for Protocol Settings (See “SoftwareSettings with Computer,” in the Starter Guide.)Specify the machine’s IP address so that the machine and thenetwork computer can communicate before making protocolsettings. Any of the following can be used to specify the settings.Machine’s operation panel (Additional Functions menu)NetSpot Device Installer (Canon utility software included in theUser Software CD)––3. Basic Network SettingsSet up the basic network settings between the machine andcomputers on your network. To specify the settings, use:Machine’s operation panelWeb browser (Remote UI)If you are changing the Network Settings, the machine must berestarted to enable the settings. Turn off the main power switch ofthe machine, wait at least 10 seconds, and turn the power back on.Settings from the Operation PanelYou can select the printing method over a TCP/IP network.The default setting is for |
