| 
1234567891011Back NextPreviousTOP10-25Before Using theMachineDocument and PaperCopyingSending and Receiving (MF6595cx/MF6595/MF6590 Only)Printing andScanningNetwork (MF6595cx/MF6595/MF6590/MF6540 Only)Remote UI (MF6595cx/MF6595/MF6590/MF6540 Only)System SettingsMaintenanceTroubleshootingAppendixIndexTable of ContentsFaxes sent from the machine are spotted or dirty.Is the recipient’s machine working properly?Check the machine by making a copy. If the copy isclear, the problem may be in the recipient’s machine.If the copy is spotted or dirty, clean the scannercomponents. (See “Scanning Area,” on p. 2-3.)Is the document loaded correctly?Make sure the document is correctly loaded. (See“Loading Documents,” on p. 2-4.)The documents you sent are too light.Is the density set to the <–LT> side?Set the density to the side.Are the scanning components of the machineclean?If the received document is spotted or dirty, clean thescanning components. (See “Scanning area,” on p. 9-8.)QAQAQAQASending of documents is too slow.Is the resolution set to , , or?Setting the resolution to reduces thesending time.Is Error Correction Mode (ECM) set to ?Because ECM corrects errors during a transmission,any problems on the line can mean that thetransmission will take extra time. Set ECM to .(See “ECM TX,” on p. 11-14.)Cannot send using Error Correction Mode (ECM).Does the recipient’s machine support ECM?If the recipient’s machine does not support ECM,the document is sent in normal mode without errorchecking.QAQAQA |
