HP-GL/2 problemsHP-GL/2 problemsWith HP-GL/2, printing is misaligned ...................................................................................................................... 547Lines or images are missing in printed HP-GL/2 jobs. .................................................................................... 547Lines are printed too thick or thin in HP-GL/2 print jobs .............................................................................. 547HP-GL/2 jobs are printed in monochrome (or color) ...................................................................................... 547Printed colors of lines are inaccurate during HP-GL/2 printing ................................................................. 547HP-GL/2 jobs are printed 6 mm larger than specified ................................................................................... 548HP-GL/2 jobs are printed at maximum size, even if a standard size is specified ............................... 548HP-GL/2 printing takes a long time ......................................................................................................................... 548Replotting with HP-GL/2 jobs is not possible. .................................................................................................... 548The printer stops when printing a HP-GL/2 job (the carriage stops moving) ...................................... 548With HP-GL/2, printing is misalignedWith HP-GL/2, printing is misalignedCause Corrective ActionThe plotter origin is incorrect. Check the printing commands.The Margin setting in the Control Panel menu is incorrect. Adjust the Margin setting values in the Control Panel menu.Lines or images are missing in printed HP-GL/2 jobs.Lines or images are missing in printed HP-GL/2 jobs.Cause Corrective ActionThe memory is full. Check the size of the data in the print job.An HP-GL/2 command not supported by this printer was received. Check the print job and settings.The printer has received print data that includes HP RTL commandswhen Auto Rotate is On in the Control Panel menu.In the Control Panel, set Auto Rotate to Off and print again.(See "Menu Settings.") ➔ P.414PageSizeProcess1 in the Control Panel menu is set to On. Set PageSizeProcess1 to Off in the Control Panel menu.(See "Menu Settings.") ➔ P.414Lines are printed too thick or thin in HP-GL/2 print jobsLines are printed too thick or thin in HP-GL/2 print jobsCause Corrective ActionThe Width setting in the Control Panelmenu is incorrect.Change the Width setting configured in Pen no. of the Palette A or Palette B selected inthe Control Panel menu.(See "Menu Settings.") ➔ P.414ThickenFineLines in the Control Panelmenu is set to Off.If fine lines are printed faintly, setting ThickenFineLines to On will print the lines moredistinctly.(See "Menu Settings.") ➔ P.414HP-GL/2 jobs are printed in monochrome (or color)HP-GL/2 jobs are printed in monochrome (or color)Cause Corrective ActionThe Color Mode setting in theControl Panel menu is incor-rect.Check the Color Mode setting in the Control Panel menu.(See "Menu Settings.") ➔ P.414However, for optimal Printhead performance, the printer consumes trace amounts of color ink evenwhen Monochrome is selected as Color Mode.Printed colors of lines are inaccurate during HP-GL/2 printingPrinted colors of lines are inaccurate during HP-GL/2 printingCause Corrective ActionAdjustFaintLines is On in the Con-trol Panel menu.Setting AdjustFaintLines to Off in the Control Panel menu may help produce the expectedresults. However, lines in some colors may appear broken.iPF780 With HP-GL/2, printing is misalignedUser's GuideTroubleshooting HP-GL/2 problems547
