Cause Corrective ActionThe loaded paper is too small. Press ▲ or ▼ to select Stop Printing, and then press the OK button."Remove paper and check pap. size"Cause Corrective ActionA sheet has come out of the printer during printing. 1. Press the Release Lever back and remove the paper.2. Reload the sheet, aligning it with the guide on the right.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" is shown onthe Display Screen, press the OK button.Printing will resume, starting from the page on which the error occurred.(See "Loading Sheets in the Printer.") ➔ P.356PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panel menuis set to Pause, the width of the loaded roll does notmatch the width specified in Fit Roll Paper Width inthe printer driver.Press ▲ or ▼ to select Print, and then press the OK button to resume print-ing.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Follow these steps to replace the roll to match the width specified in theprinter driver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") ➔ P.343(See "Removing the Roll Holder from Rolls.") ➔ P.3452. Replace with paper of the width configured in the printer driver.(See "Attaching the Roll Holder to Rolls.") ➔ P.336(See "Loading Rolls in the Printer.") ➔ P.339The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you se-lect Fit Roll Paper Width in the printer driver matches the width of the rollloaded in the printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loadedaskew, or warped paperhas been loaded.Follow these steps to reload the roll.1. Press the OK button and reload the paper.(See "Loading Rolls in the Printer.") ➔ P.3392. Pull the Release Lever forward.3. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, pressthe OK button.Printing will resume, starting from the page on which the error occurred.If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly inuntil it touches the Roll Holder flange, and reload the Roll Holder in the printer.(See "Attaching the Roll Holder to Rolls.") ➔ P.336Follow these step to reload a sheet.1. Push the Release Lever back.2. Load the sheet, aligning it with the guide on the right.(See "Loading Sheets in the Printer.") ➔ P.356PaprWidth Mismatch iPF780User's GuideError Message Messages regarding paper558
