Cause Corrective ActionPaper has been loadedaskew, or warped paperhas been loaded.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, pressthe OK button.Printing will resume, starting from the page on which the error occurred.Insufficient paper for jobInsufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paper left whenManageRemainRoll in the Control Panel menu is On.Press ▲ or ▼ to select Print, and then pressthe OK button to resume printing.However, the roll paper may run out during theprint job and you may not be able to print all ofthe document.Press ▲ or ▼ to select Change Paper, andthen press the OK button to stop printing.Either change the printer driver Paper Sourcesetting or the GL2 Settings > Paper Sourcesetting in the printer menu or replace the rollwith a roll that has enough paper for the printjob, and then try printing again.(See "Removing the Roll from the Print-er.") ➔ P.343(See "Loading Rolls in the Printer.") ➔ P.339Press ▲ or ▼ and select Stop Printing orpress the Stop button to stop printing.This paper cannot be used.This paper cannot be used.Cause Corrective ActionPaper smaller than the printer's minimum supportedsize has been loaded.Push the Release Lever back and load paper of the correct size.(See "Paper Sizes.") ➔ P.326Paper has been loaded that is too small to print thetest pattern for printhead adjustment or nozzle check-ing.Push the Release Lever back and load unused paper of A4 size or larger.More than one sheet may be required depending on the adjustment.Roll printing is selected.Roll printing is selected.Cause Corrective ActionYou have attempted to print on a roll,but no roll is loaded.Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll,and then print.(See "Attaching the Roll Holder to Rolls.") ➔ P.336(See "Loading Rolls in the Printer.") ➔ P.339Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.Roll printing is selected, but sheets are loaded.Roll printing is selected, but sheets are loaded.Cause Corrective ActionA print job for rolls was received when asheet is loaded.Follow these steps to load and print on a roll.1. Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove the sheet.(See "Removing Sheets.") ➔ P.3602. Load a new roll.(See "Loading Rolls in the Printer.") ➔ P.339The printer now starts printing the print job.Press ▲ or ▼ to select Stop Printing, and then press the OK button.The roll is empty.The roll is empty.Cause Corrective ActionThe roll is empty. Follow these steps to replace the used roll with a new roll of the same type and size.iPF780 Insufficient paper for jobUser's GuideError Message Messages regarding paper559
