HP-GL/2 jobs are printed 6 mm larger than specifiedHP-GL/2 jobs are printed 6 mm larger than specifiedCause Corrective ActionThe page size of the HP-GL/2 print job, as created in the source appli-cation, is incorrect.In the Control Panel menu, set PageSizeProcess1 to On.(See "Menu Settings.") ➔ P.414HP-GL/2 jobs are printed at maximum size, even if a standard size is specifiedHP-GL/2 jobs are printed at maximum size, even if a standard size is specifiedCause Corrective ActionThe page size of the HP-GL/2 print job, as createdin the source application, is incorrect.In the Control Panel menu, set PageSizeProcess2 or Conserve Paper to On.The layout will be changed to the optimal layout.(See "Menu Settings.") ➔ P.414HP-GL/2 printing takes a long timeHP-GL/2 printing takes a long timeCause Corrective ActionLarge print jobs with a lot of data take longer to print. Please wait a while until printing is finished.A job was printed when Input Resolution in the ControlPanel menu was set to 600dpi.In the Control Panel menu, set Input Resolution to 300dpi and printagain.(See "Menu Settings.") ➔ P.414Replotting with HP-GL/2 jobs is not possible.Replotting with HP-GL/2 jobs is not possible.Cause Corrective ActionThe data was lost because of replot-ting.Data for replotting is lost after the following operations. In this case, send the print job again.• The memory buffer was cleared from the Control Panel.• The printer was turned off.• The printer has received a new HP-GL/2 print job.• Printing has been canceledThe printer stops when printing a HP-GL/2 job (the carriage stops moving)The printer stops when printing a HP-GL/2 job (the carriage stops moving)Cause Corrective ActionThe printer is analyzing the print job. Please wait a while until printing is finished.A job was printed when Input Resolution in the ControlPanel menu was set to 600dpi.In the Control Panel menu, set Input Resolution to 300dpi and printagain.(See "Menu Settings.") ➔ P.414HP-GL/2 jobs are printed 6 mm larger than specified iPF780User's GuideTroubleshooting HP-GL/2 problems548
