Casio AT-5 User Manual

Also see for AT-3: Guidelines

Contents

Casio AT-5 User Manual Manual pdf 135 page image

Using a Memory CardE-1334. Use the R-17 (t, y) buttons to move the 0 to“CardFormat”.5. Press the R-16 (ENTER) button.• This will cause the confirmation message “Sure?” toappear.6. Press the R-14 (YES) button to format thememory card or the R-14 (NO) button to cancel.• The message “Please Wait” will remain on the displaywhile the format operation is being performed. Do notperform any Digital Keyboard operation while thismessage is on the display. “Complete” appears on thedisplay after formatting is complete.• Formatting may take as long as a few minutes tocomplete.1. Insert the memory card into the card slot.2. If the Digital Keyboard is in the card mode,press the C-9 (CARD) button to exit the cardmode.3. Depending on the type of data you want to saveto the memory card, perform one of the stepsshown below.• All setup registration banks are saved as a batch. Otherdata is saved in area (data item) units.4. While holding down the R-13 (FUNCTION)button, press the C-9 (LOAD/SAVE) button.• This causes an “Xxxx Load”*1 screen like the oneshown below to appear. The sample screen belowshows the screen that appears from the rhythm screen.Saving Digital Keyboard Data to aMemory CardTo save Digital Keyboard data to a memorycardTo save thistype of data: Do this:One user rhythm 1. Press the L-9 ([F] USER RHYTHMS)button.2. Use the dial or R-14 (–, +) buttons tospecify the user rhythm number.One user tone 1. Press the R-12 ([L] USER TONES)button.2. Use the dial or R-14 (–, +) buttons tospecify the user tone number.One user DSP 1. Perform steps 1 through 4 under “To usea DSP” (page E-34).2. Use the dial or R-14 (–, +) buttons tospecify the user DSP number (101through 200).One user preset 1. While holding down the L-7 ([D] ARABIC/ORIENTAL) button, press the L-8 ([E]PIANO RHYTHMS) button to display themusic preset screen.2. Press the L-9 ([F] USER RHYTHMS)button.3. Use the dial or R-14 (–, +) buttons tospecify the user preset number.One songsequencer song1. Press the C-5 (SONG SEQUENCER)button to enter the song sequencer mode.2. Use the dial or R-14 (–, +) buttons tospecify the song number.All registrationbanksPress the C-10 (BANK) button to display theregistration bank selection screen.All scale memorydataWhile holding down the R-13 (FUNCTION)button, press the C-8 (SCALE) button todisplay the scale screen.