Casio AT-5 User Manual

Also see for AT-3: Guidelines

Contents

Casio AT-5 User Manual Manual pdf 45 page image

Using the MixerE-43Part parameters include setting items that can be adjusted for parts A01 through A16 and B01 through B16.Part ParametersParameter Name Description Setting RangeTONE(Part Tone)Specifies a tone for each part. When configuring this parameter, you can use thebuttons R-1 ([A] PIANO) through R-12 ([L] USER TONES) to select a tone group.A:001 to L:100Part(Part On/Off)Specifies if the notes of a particular part should be output (on) or not output (oFF).When a part is turned on, the part number is displayed along the bottom of the levelmeter. Part numbers are not displayed for parts that are turned off.When playing back a MIDI file or song sequencer song, a “Sol” (Solo) option can bespecified to play a specific part only. To switch to “Sol”, press both R-14 (–, +)buttons at the same time.oFF, on*Volume(Part Volume)Specifies the volume level of each part. 0 to 127*Pan(Part Pan)Specifies the stereo pan position of each part. 0 indicates the center, while a smallervalues shifts to the left and a larger value shifts to the right.–64 to 0* to +63CoarseTune(Part Coarse Tune)Specifies, in semitone steps, the pitch of the notes of each part. –24 to 0* to +24FineTune(Part Fine Tune)Specifies, in cent steps, the pitch of the notes of each part. –99 to 0* to +99BendRange(Part Bend Range)Specifies the bend range of each part. 0 to 2* to 24DSP Line(Part DSP Line)Specifies whether DSP should be applied to each part. Changing this setting from“oFF” to “on” automatically switches the “Cho/DSP” setting (page E-41) to “DSP”.oFF*, onRev.Send(Part Reverb Send)Specifies how much reverb is applied to each part.No reverb is applied at all when this setting is 0, while maximum reverb is appliedwhen it is 127.0 to 40* to 127Cho.Send(Part Chorus Send)Specifies how much chorus is applied to each part.No chorus is applied at all when this setting is 0, while maximum chorus is appliedwhen it is 127.0* to 127Scale(Part Scale Enable)Specifies whether scale (page E-22) settings should be applied (on) or should not beapplied (oFF). Equal temperament is applied to parts when this setting is “oFF”.oFF*, onB