Casio AT-5 User Manual

Also see for AT-3: Guidelines

Contents

Casio AT-5 User Manual Manual pdf 136 page image

Using a Memory CardE-1345. Press the R-17 (y) button to change to the“Xxxx Save”*1 screen.• To save a song sequencer song in SMF format, pressthe R-17 (y) button one more time here to display the“Seq SmfSave” screen. You can switch between the“Xxxx Load”, “Seq Save”, and “Seq SmfSave” screensusing the R-17 (t, y) buttons.6. Enter the file name to assign to the data when itis stored.Change the initial default file name “USERNAME.xxx”*2as described below.• The characters you can select are shown below.7. After everything is the way you want, press theR-16 (ENTER) button.8. In response to the “Sure?” message thatappears, press the R-14 (YES) button to save orthe R-14 (NO) button to cancel.• Performing the above procedure to write a song sequencersong to an SMF format file will save the data as SMFFormat 0 (16 channel) data. System track data A01 throughA16 are saved respectively to SMF 01CH through 16CH,while song tracks 01 through 16 are saved respectively toSMF 01CH through 16CH. Note that the save operationgives priority to the data of tracks 01 through 16. If there isdata in any of the tracks 01 through 16 and “On” is selectedfor the “Part On/Off” setting of a track that contains data,the system track data (A01 through A16) for the samenumbered track data will not be saved. Also, the noteevents of tracks that are turned off using the mixer are notsaved.1. Press the C-9 (CARD) button to enter the cardmode.2. While holding down the R-13 (FUNCTION)button, press the C-17 (MENU) button.• This displays the function menu “Play/CardUtl” screen.3. Use the R-17 (t, y) buttons to move the 0 to“AllData” and then press the R-16 (ENTER)button.4. When the “All Load” screen appears, use theR-17 (y) button to change to the “All Save”screen.• The remainder of the steps are the same as those fromstep 6 under “To save Digital Keyboard data to amemory card” (page E-133).(1) Use the R-17 (u, i) buttons to move the cursor tothe character you want to change.(2) Use the dial or the R-14 (–, +) buttons to change thecharacter.*1 The “Xxxx” part of the file name depends the type ofdata you are saving.*2 The “xxx” part of the file name is a file name extensionthat depends the type of data you are saving.9JT'8IS_`7HR&~6GQS@5FPZ}4EOY{3DNX^2CMW-1BLV)0AKU(To batch save all Digital Keyboard data to amemory card