IP setting using SetIP Program (Windows)This program is used to manually set the network IP address of your machine using its MACaddress to communicate with the machine. The MAC address is the hardware serial numberof the network interface and can be found in the Network Configuration Report.See "Setting IP address"Configuring the machine’s wireless networkBefore starting you will need to know the network name (SSID) of your wireless network andthe Network Password if it is encrypted. This information was set when the access point (orwireless router) was installed. If you do not know about your wireless environment, pleaseask the person who set up your network.Turning the Wi-Fi network on/off (Dell B2375dfw MonoMFP only)There are two methods available to disconnect the wireless network on your machine.a Press (WPS) button (on the control panel) less than 2 secondsthe home screen) Off .Wi-Fi (fromb Press My Settings Machine SetupActivate Off from the home screen.Network Setup Wi-Fi Wi-FiAlso you can turn the Wi-Fi network on/off in the Embedded Web Service.1 Check whether the machine is connected to the network.2 Start a web browser such as Internet Explorer, Safari, or Firefox and enter yourmachine’s new IP address in the browser window.For example,3 Click Login on the upper right of the Embedded Web Service website.4 Type in the ID and Password then click Login.If it’s your first time Logging intoEmbedded Web Service, type in the below default ID and password. We recommendyou to change the default password for security reasons.• ID: admin• Password: admin5 When the Embedded Web Service window opens, click Settings NetworkSettings.6 Click Wireless Custom.You can also turn the Wi-Fi network on/off.- 236