CONFIG-FRRP mode.no disableConfiguring and Adding the Member VLANsControl and member VLANS are configured normally for Layer 2. Their status as Control or Member is determined at the FRRP groupcommands.For more information about configuring VLANS in Layer 2 mode, refer to the Layer 2 chapter.Be sure to follow these guidelines:• All VLANS must be in Layer 2 mode.• Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be tagged or untagged.• The control VLAN must be the same for all nodes on the ring.To create the Members VLANs for this FRRP group, use the following commands on all of the Transit switches in the ring.1 Create a VLAN with this ID number.CONFIGURATION mode.interface vlan vlan-idVLAN ID: the range is from 1 to 4094.2 Tag the specified interface or range of interfaces to this VLAN.CONFIG-INT-VLAN mode.tagged interface {range}Interface:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the stack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.3 Assign the Primary and Secondary ports and the Control VLAN for the ports on the ring.CONFIG-FRRP mode.interface primary interface secondary interface control-vlan vlan idInterface:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the stack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.VLAN ID: Identification number of the Control VLAN.4 Configure a Transit node.CONFIG-FRRP mode.mode transit5 Identify the Member VLANs for this FRRP group.328 Force10 Resilient Ring Protocol (FRRP)
