CONFIG-FRRP mode.member-vlan vlan-id {range}VLAN-ID, Range: VLAN IDs for the ring’s Member VLANs.6 Enable this FRRP group on this switch.CONFIG-FRRP mode.no disableSetting the FRRP TimersTo set the FRRP timers, use the following command.NOTE: Set the Dead-Interval time 3 times the Hello-Interval.• Enter the desired intervals for Hello-Interval or Dead-Interval times.CONFIG-FRRP mode.timer {hello-interval|dead-interval} milliseconds• Hello-Interval: the range is from 50 to 2000, in increments of 50 (default is 500).• Dead-Interval: the range is from 50 to 6000, in increments of 50 (default is 1500).Clearing the FRRP CountersTo clear the FRRP counters, use one of the following commands.• Clear the counters associated with this Ring ID.EXEC PRIVELEGED mode.clear frrp ring-idRing ID: the range is from 1 to 255.• Clear the counters associated with all FRRP groups.EXEC PRIVELEGED mode.clear frrpViewing the FRRP ConfigurationTo view the configuration for the FRRP group, use the following command.• Show the configuration for this FRRP group.CONFIG-FRRP mode.show configurationViewing the FRRP InformationTo view general FRRP information, use one of the following commands.Force10 Resilient Ring Protocol (FRRP) 329
