Defined as:seq 5 permit ip 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234 222.222.222.222/24 eq 40 ack,Next-hop reachable(via Te 1/1/1/1),Applied interfaces:Te 1/1/1/2NOTE: If you apply the redirect-list to an interface, the output of the show ip redirect-list redirect-list-name command displays reachability status for the specified next-hop.Example: Showing CAM PBR ConfigurationDell(conf)#cam-acl l2acl 2 ipv4acl 2 ipv6acl 0 ipv4qos 0 l2qos 0 l2pt 0 ipmacacl 1 vman-qos0 ipv4Pbr 4Dell#show cam pbr stack-unit 1 port-set 0TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FINCam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hop EgressIndex Flag Port Port MAC Port------------------------------------------------------------------------------------------00001 Fi 1/21/1 N/A TCP 0x0 0 0 155.55.0.0/16 222.22.2.0/24 00:00:00:00:00:04 Te 1/1/1/400002 Fi 1/21/1 N/A 19 0x0 0 0 155.55.0.0/16 222.22.2.0/24 00:00:00:00:00:04 Te 1/1/1/400003 Fi 1/21/1 N/A UDP 0x0 0 0 155.55.0.0/16 222.22.2.0/24 00:00:00:00:00:04 Te 1/1/1/4Sample ConfigurationYou can use the following example configuration to set up a PBR. These are not comprehensive directions but are intended to give you aguidance with typical configurations. You can copy and paste from these examples to your CLI. Make the necessary changes to supportyour own IP addresses, interfaces, names, and so on.The Redirect-List GOLD defined in this example creates the following rules:• description Route Gold traffic to the DS3• seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.1.0/24”• seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.2.0/24”• seq 15 permit ip anyPolicy-based Routing (PBR) 617
