• interface: the type, slot, and number of an interface.To view the configuration changes, use the show config command in ROUTER RIP mode.Debugging RIPThe debug ip rip command enables RIP debugging.When you enable debugging, you can view information on RIP protocol changes or RIP routes.To enable RIP debugging, use the following command.• debug ip rip [interface | database | events | trigger]EXEC privilege modeEnable debugging of RIP.Example of the debug ip rip CommandThe following example shows the confirmation when you enable the debug function.Dell#debug ip ripRIP protocol debug is ONDell#To disable RIP, use the no debug ip rip command.RIP Configuration ExampleThe examples in this section show the command sequence to configure RIPv2 on the two routers shown in the following illustration —Core 2 and Core 3.The host prompts used in the following example reflect those names. The examples are divided into the following groups of commandsequences:• Configuring RIPv2 on Core 2• Core 2 RIP Output• RIP Configuration on Core 3• Core 3 RIP Output• RIP Configuration SummaryFigure 110. RIP Topology Example704 Routing Information Protocol (RIP)
