Pluggable media not presentInterface index is 46449666Internet address is 10.11.131.240/23[output omitted]Dell#show ip routeCodes: C - connected, S - static, R - RIP,B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,> - non-active route, + - summary routeGateway of last resort is 10.11.131.254 to network 0.0.0.0Destination Gateway Dist/Metric Last Change----------- ------- ----------- -----------*S 0.0.0.0/0 via 10.11.131.254, Te 1/1/1/1 1/0 1d2hC 10.11.130.0/23 Direct, Te 1/1/1/1 0/0 1d2hDell#VLAN InterfacesVLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of VLANs.For more information about VLANs and Layer 2, see Layer 2 and Virtual LANs (VLANs).NOTE: To monitor VLAN interfaces, use Management Information Base for Network Management of TCP/IP-based internets:MIB-II (RFC 1213).NOTE: You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.Dell Networking OS supports Inter-VLAN routing (Layer 3 routing in VLANs). You can add IP addresses to VLANs and use them in routingprotocols in the same manner that physical interfaces are used. For more information about configuring different routing protocols, refer tothe chapters on the specific protocol.A consideration for including VLANs in routing protocols is that you must configure the no shutdown command. (For routing traffic toflow, you must enable the VLAN.)NOTE: You cannot assign an IP address to the default VLAN, which is VLAN 1 (by default). To assign another VLAN ID to thedefault VLAN, use the default vlan-id vlan-id command.To assign an IP address to an interface, use the following command.• Configure an IP address and mask on the interface.INTERFACE modeip address ip-address mask [secondary]• ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in slash format (/24).• secondary: the IP address is the interface’s backup IP address. You can configure up to eight secondary IP addresses.Example of a Configuration for a VLAN Participating in an OSPF Processinterface Vlan 10ip address 1.1.1.2/24tagged TenGigabitEthernet 1/1/2/1-1/1/4/4tagged TenGigabitEthernet 5/1/1ip ospf authentication-key force10ip ospf cost 1ip ospf dead-interval 60ip ospf hello-interval 15no shutdown!Interfaces 365
