Tracking states for 2 resource Ids:2 - Up IPv6 route, 2040::/64, priority-cost 20, 00:02:113 - Up IPv6 route, 2050::/64, priority-cost 30, 00:02:11The following example shows verifying the VRRP configuration on an interface.Dell#show running-config interface tengigabitethernet 1/1/8/1interface TenGigabitEthernet 1/1/8/1no ip addressipv6 address 2007::30/64vrrp-ipv6-group 1track 2 priority-cost 20track 3 priority-cost 30virtual-address 2007::1virtual-address fe80::1no shutdownSetting VRRP Initialization DelayWhen configured, VRRP is enabled immediately upon system reload or boot. You can delay VRRP initialization to allow the IGP and EGPprotocols to be enabled prior to selecting the VRRP Master. This delay ensures that VRRP initializes with no errors or conflicts. You canconfigure the delay for up to 15 minutes, after which VRRP enables normally.NOTE: When you reload a node that contains VRRP configuration and is enabled for VLT, Dell Networking recommends that youconfigure the reload timer by using the vrrp delay reload command to ensure that VRRP is functional. Otherwise, whenyou reload a VLT node configured for VRRP, the local destination address is not seen on the reloaded node causing suboptimalrouting.Set the delay timer on individual interfaces. The delay timer is supported on all physical interfaces, VLANs, and LAGs.When you configure both CLIs, the later timer rules VRRP enabling. For example, if you set vrrp delay reload 600 and vrrpdelay minimum 300, the following behavior occurs:• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured forVRRP.• When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.To set the delay time for VRRP initialization, use the following commands.• Set the delay time for VRRP initialization on an individual interface.INTERFACE modevrrp delay minimum secondsThis time is the gap between an interface coming up and being operational, and VRRP enabling.The seconds range is from 0 to 900.The default is 0.• Set the delay time for VRRP initialization on all the interfaces in the system configured for VRRP.INTERFACE modevrrp delay reload secondsThis time is the gap between system boot up completion and VRRP enabling.The seconds range is from 0 to 900.958 Virtual Router Redundancy Protocol (VRRP)
