• permanent: keep the static route in the routing table (if you use the interface option) even if you disable the interface withthe route. (optional)• tag tag-value: the range is from 1 to 4294967295. (optional)Example of the show ip route static CommandTo view the configured routes, use the show ip route static command.Dell#show ip route staticDestination Gateway Dist/Metric Last Change----------- ------- ----------- -----------S 2.1.2.0/24 Direct, Nu 0 0/0 00:02:30S 6.1.2.0/24 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.2/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.3/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.4/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.5/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.6/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.7/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.8/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.9/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.10/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.11/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.12/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.13/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.14/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.15/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.16/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 6.1.2.17/32 via 6.1.20.2, Te 1/1/1/1 1/0 00:02:30S 11.1.1.0/24 Direct, Nu 0 0/0 00:02:30Direct, Lo 0--More--Dell Networking OS installs a next hop that is on the directly connected subnet of current IP address on the interface.Dell Networking OS also installs a next hop that is not on the directly connected subnet but which recursively resolves to a next hop on theinterface's configured subnet.• When the interface goes down, Dell Networking OS withdraws the route.• When the interface comes up, Dell Networking OS re-installs the route.• When the recursive resolution is “broken,” Dell Networking OS withdraws the route.• When the recursive resolution is satisfied, Dell Networking OS re-installs the route.Configure Static Routes for the ManagementInterfaceWhen an IP address that a protocol uses and a static management route exists for the same prefix, the protocol route takes precedenceover the static management route.To configure a static route for the management port, use the following command.• Assign a static route to point to the management interface or forwarding router.CONFIGURATION modemanagement route ip-address mask {forwarding-router-address | ManagementEthernet slot/port}Example of the show ip management-route CommandTo view the configured static routes for the management port, use the show ip management-route command in EXEC privilegemode.Dell#show ip management-routeDestination Gateway State Route Source----------- ------- ----- ------------IPv4 Routing 399
