Eaton C441R User Manual

Also see for C441 Series: User manual

Contents

59User Manual MN04200002EEffective January 2016C441 Ethernet module user manual(C441R, C441T, C441U, C441V)EATON www.eaton.comTable 101. Register Definition for the S611 Soft Starter (Cont.)StartCoil Register Read/Write Name Description (Units)- 3000 R/W ModbusConsumptionListThe Production and consumptionRegisters can be used to create customModbus interface ranges. An example:If field inputs register address 0 is putinto the first slot of the productionlist, the field inputs register value willbe available in the first slot of theModbus Production Data Register range.Production data is data provided by thedevice and Consumption data is fordata provided (written) to the device.Note that the values must be ModbusRegister Address (i.e., RegisterNumber - 1) not Register Number.- 4000 R/W ModbusConsumptionData-7.5 Register Definitions for S811+ Soft StarterTable 102. Register Definitions for S811+ Soft StarterStartCoil Register Read/Write Name Description (Units)1 1 R Field Inputs A bitfield representing the input points.Bit = Description0 = Input 11 = Input 22 = Input 33 = Input 4- 2 R ControlVoltage Adapter source voltage. ( mV )- 3 R AmbientTemperature Device ambient temperature as mea-sured from the PCB. ( °C )- 4 R/W Max BoardTemperature The maximum board temperature experi-enced since manufacturing. ( °C )65 5 R Dip SwitchValue A bit field representing the present stateof the dip switches.- 6 R ConfigurationCRC A CRC value calculated over the non-volatile data present.- 7 R/W Serial Number 32bit Com Adapter Device SerialNumber.- 9 R Firmware Rev Com Adapter Firmware Rev.- 11 R/W Hardware Rev Com Adapter Hardware Rev.1601 101 R/W Field RelayOutputs Warning: changing this value may causethe output relay(s) to change state.A bitfield representing the output points.Bit = Description0 = Output 11 = Output 2Value 0x00: Output 1 Off, Output 2 OffValue 0x01: Output 1 On, Output 2 OffValue 0x02: Output 1 Off, Output 2 OnValue 0x03: Output 1 On, Output 2 On- 102 R/W Field InputsDebounce Array of debounce values. A debouncevalue exists for each input. Thedebounce applies to both rising andfalling edge.Web interface setting examples (commaseparated values):10,10,10,10 change all four debouncevalues to 10 msec;15,20 changes the first two debouncevalues to 15 msec and 20 msec andleaves the rest unchanged;,,,30 changes the last debounce value to30 and leaves the first three unchanged( milliseconds )- 110 R/W Modbus TCPCom Timeout Communication timeout for Modbus TCP.0 = Disable. ( milliseconds )1761 111 R/W Field RelayFault Action When a communication fault occursthe relays can execute two types ofbehavior. The behavior is selected on aper bit basis.Bit = Description0 = Relay 11 = Relay 2Bit Value = Description0 = Apply Fault Value1 = No Change1777 112 R/W Field RelayFault State Communication fault value to beapplied. A bitfield where each bitdefines an output point.Bit Value = Description0 = Turn Relay Off1 = Turn Relay On