Behavior of the SmartWire-DTgateway11102/11 MN05006002Z-ENSWD LED (status of SmartWire-DT network)Table 21: Diagnostics with the SWD-LEDEvent Explanation RemedyLED green contin-uous lightAll SmartWire-DT slaves stored in thetarget configuration are available.–LED red contin-uous lightNo connection of SmartWire-DTgateway with the SmartWire-DTnetwork or there is a short circuitingof the 15 V DC device voltageCheck the spade connection on theSmartWire-DT gateway or the crimpconnections of the plugs on theSmartWire-DT ribbon cable.LED red flashing(1 Hz)After initial switch-on:the SmartWire-DT gateway hasdetected SmartWire-DT slaves on theSmartWire-DT network, no actual ortarget configuration exists yet.Make sure that all required Smart-Wire-DT stations are present andcorrectly connected to the SmartWire-DT network.Then press the Config. key to reassignaddresses.After retriggering with the existenceof a target configuration: at least oneSmartWire-DT slave too many or toofew has been found in comparisonwith the target configuration.Make sure that all required Smart-Wire-DT stations are present andcorrectly connected to the SmartWire-DT network.Then press the Config. key to reassignaddresses.During address assignment:The connection between the gatewayand the SmartWire-DT network isinterrupted or no SmartWire-DTslaves were found. This applies also ifthe external device plug at the firstSmartWire-DT has been pulled.Check the connection betweengateway and SmartWire-DT network.Also check that the device plugs areconnected correctly to the SmartWire-DT slaves.LED orangeflashing (1 Hz)Transient state while the SmartWire-DT gateway is determining the targetconfiguration.–LED greenflashing(1 Hz)Transient state until the actualconfiguration found has been storedinternally as a target configuration.–LED off No power supply Check the power supply.www.comoso.com