SmartWire-DT network2502/11 MN05006002Z-ENTable 4: LED of the SmartWire-DT gateway after download ofthe PLC configurationFor a brief description of how an SmartWire-DT gateway isput into operation for the first time with a new actual config-uration please refer to Section “Initial switch-on of theSmartWire-DT network”, page 99.In the manual MN05013002Z-EN, “SmartWire-DT Gate-ways“, you can find out how to configure a SmartWire-DTgateway with its SmartWire-DT slaves in the configurationsoftware for the PLC.Organization of the SmartWire-DT slave dataAll cyclic I/O data of existing SmartWire-DT stations areplaced in a data storage area of the SmartWire-DT gateway.This data storage area comprises up to 1024 bytes. Thecyclic data exchange between the coordinator and all Smart-Wire-DT stations takes place in a common message.Each SmartWire-DT slave reads the receive data intended forit (input byte) and writes its send data (output bytes).The data are declared valid at the end of the transfer cycle,after error-free completion of the telegram verification.Each SmartWire-DT slave can now accept the new receivedata at the same point in time and prepare its send data forthe next transfer cycle.LED StatusSWD Green continuous lightConfig. Green continuous lightCAN or DP green continuous light when data is beingexchanged on the field busPOW yellow continuous lightwww.comoso.com
