Installation6402/11 MN05006002Z-ENInstallation of the surface mounting enclosureThe circuit-board in the surface mounting enclosure isconnected to the SmartWire-DT network with the Smart-Wire-DT round cable.The SmartWire-DT round cable can be connected directlywith V-M20 × 1.5 mm (metric cable gland with integratedstrain relief) or plugged in (a “Direct connection of Smart-Wire-DT round cable“, page 65).8-pole enclosure bushings with a screw fixingM20 x 1.5 mm as plug/socket versions are used for the plug-in version (a “Plug-in connection of the SmartWire-DTround cable“, page 66).Connection on the PCB is performed via eight numbered andcolour-coded spring-cage terminals. This applies to theincoming SmartWire-DT cable on the PCB side marked INand to the outgoing SmartWire-DT cable on the OUT side.The SmartWire-DT round cable and SmartWire-DT enclosurebushings have the same wire colours.Connection to the printed circuit boardFigure 17: Printed circuit boardX Place the PCB in the mounting of the surface mountingenclosure so that the terminal strip is lying with themarking IN on the side of the incoming SmartWire-DTround cable.INOUTOFFONwww.comoso.com
