Components of theSmartWire-DT system1502/11 MN05006002Z-ENWith the SmartWire-DT components a differentiation ismade between SmartWire-DT slaves and SmartWire-DTelements.SmartWire-DT slaves are all SmartWire-DT components thatrespond to a request from the SmartWire-DT gateway, i.e.can exchange data. They are given an SmartWire-DT slaveaddress.SmartWire-DT elements are passive SmartWire-DT compo-nents that do not exchange any data, but are necessary foroperation of the SmartWire-DT network. SmartWire-DTelements are, for example, the power feeder modules,SmartWire-DT cables, adapters etc. SmartWire-DT elementsare not given an SmartWire-DT slave address.SmartWire-DT slaveSmartWire-DT gateways for PROFIBUS-DP orCANopenThe most important SmartWire-DT slave in the SmartWire-DT network is the SmartWire-DT gateway with its coordi-nator function.For a short description of how you install and plan yourSmartWire-DT gateway please refer to Chapter “Engi-neering”, page 29 and Chapter “Installation”, page 47.For a detailed description please refer to the manualMN05013002Z-EN „SmartWire-DT Gateways“.Below you will find a short report of the SmartWire-DT slavesthat are currently available. For a detailed description of allSmartWire-DT slaves please refer to the manualMN05006001Z-EN, „SmartWire-DT Slaves“.SmartWire-DT I/O modulesThe SmartWire-DT I/O modules connect conventionalsensors and actuators to the SmartWire-DT network.These can include, auxiliary contacts of additional switch-gear without built-in SmartWire-DT technology. To reducewiring, the modules are placed immediately next to thesensors/actuators.www.comoso.com