GE Multilin C60 Breaker Protection System 6-116 ACTUAL VALUES 6.2 STATUS6b) SLOW EXCHANGEPATH: ACTUAL VALUES STATUS EGD PROTOCOL STATUS PRODUCER STATUS SLOW EXCHANGE 1(2)These values provide information that may be useful for debugging an EGD network. The EGD signature and packet sizefor the slow EGD exchanges are displayed.6.2.19 TELEPROTECTION CHANNEL TESTSPATH: ACTUAL VALUES STATUS TELEPROT CH TESTSThe status information for two channels is shown here.• CHANNEL 1 STATUS: This represents the receiver status of each channel. If the value is “OK”, teleprotection isenabled and data is being received from the remote terminal; If the value is “FAIL”, teleprotection enabled and data isnot being received from the remote terminal. If “n/a”, teleprotection is disabled.• CHANNEL 1 LOST PACKETS: Data is transmitted to the remote terminals in data packets at a rate of two packets percycle. The number of lost packets represents data packets lost in transmission; this count can be reset to 0 through theCOMMANDS CLEAR RECORDS menu.• VALIDITY OF CHANNEL CONFIGURATION: This value displays the current state of the communications channelidentification check, and hence validity. If a remote relay ID does not match the programmed ID at the local relay, the“FAIL” message will be displayed. The “N/A” value appears if the local relay ID is set to a default value of “0”, the chan-nel is failed, or if the teleprotection inputs/outputs are not enabled.6.2.20 REMAINING CONNECTION STATUSPATH: ACTUAL VALUES STATUS COMM STATUS REMAINING CONNECT SLOW EXCHANGE 1SLOW EXCHANGE 1SIGNATURE: 0MESSAGE SLOW EXCHANGE 1DATA LENGTH: 0 TELEPROT CH TESTSCHANNEL 1STATUS: n/aRange: n/a, FAIL, OKMESSAGE CHANNEL 1 LOSTPACKETS: 1Range: 1 to 65535 in steps of 1MESSAGE CHANNEL 2STATUS: n/aRange: n/a, FAIL, OKMESSAGE CHANNEL 2 LOSTPACKETS: 1Range: 1 to 65535 in steps of 1MESSAGE VALIDITY OF CHANNELCONFIGURATION: FAILRange: n/a, FAIL, OK COMM STATUS REMAINING CONNECTMMS TCP(max 5)5Range: 0 to 5MESSAGE MODBUS TCP(max 4)4Range: 0 to 4MESSAGE DNP TCP (max 2)2Range: 0 to 2MESSAGE IEC-104 (max 2)2Range: 0 to 2MESSAGE PMU TCP1Range: 1 to 4
