3-2 C60 Breaker Protection System GE Multilin3.1 DESCRIPTION 3 HARDWARE3 Figure 3–2: C60 HORIZONTAL MOUNTING (ENHANCED PANEL)Figure 3–3: C60 HORIZONTAL MOUNTING AND DIMENSIONS (STANDARD PANEL)b) VERTICAL UNITSThe C60 Breaker Protection System is available as a reduced size (¾) vertical mount unit, with a removable faceplate. Thefaceplate can be specified as either standard or enhanced at the time of ordering. The enhanced faceplate contains addi-tional user-programmable pushbuttons and LED indicators.The modular design allows the relay to be easily upgraded or repaired by a qualified service person. The faceplate ishinged to allow easy access to the removable modules, and is itself removable to allow mounting on doors with limited reardepth.The case dimensions are shown below, along with panel cutout details for panel mounting. When planning the location ofyour panel cutout, ensure that provision is made for the faceplate to swing open without interference to or from adjacentequipment.The relay must be mounted such that the faceplate sits semi-flush with the panel or switchgear door, allowing the operatoraccess to the keypad and the RS232 communications port. The relay is secured to the panel with the use of four screwssupplied with the relay.18.370”[466,60 mm]842808A1.CDR0.280”[7,11 mm]Typ. x 44.000”[101,60 mm]17.750”[450,85 mm]CUT-OUT19.00”(482.6 mm)7.00”(177.8 mm)Horizontal front viewHorizontal top view (19”, 4 RU)17.52”(445.0 mm)Bracketsrepositioned forswitchgearmounting10.90”(276.8 mm)9.80”(248.9 mm)8.97”(227.8 mm)17.75”(450.8 mm)7.13”(181.1 mm) Cutout18.37”(466.6 mm)4.00”(101.6 mm)1.57”(39.8 mm)4 × 0.28”(7.1 mm)diameter17.72”(450.1 mm)14.52”(368.8 mm)9.52”(241.8 mm)8 × 0.156 Ø5.00”(127.0 mm)0.375”(9.5 mm)0.375”(9.5 mm)Remote mounting, view from the rear of the panelBezeloutline0.375” (9.5)1.875”(47.6)0.375” (9.5)4.875”(121.5 mm)6.96”(176.8 mm)827704B4.CDR
