7-2 L60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUALCOMMANDS MENU CHAPTER 7: COMMANDS AND TARGETS77.1.1 Virtual inputsCOMMANDS VIRTUAL INPUTSThe states of up to 64 virtual inputs are changed here. The first line of the display indicates the ID of the virtual input. Thesecond line indicates the current or selected status of the virtual input. This status is a state off (logic 0) or on (logic 1).7.1.2 Clear recordsCOMMANDS CLEAR RECORDSThis menu contains commands for clearing historical data such as the event records. Data is cleared by changing acommand setting to “Yes” and pressing the ENTER key. After clearing data, the command setting automatically reverts to“No.” COMMANDS VIRTUAL INPUTS Virt Ip 1OffRange: Off, On Virt Ip 2OffRange: Off, On Virt Ip 64OffRange: Off, On COMMANDS CLEAR RECORDS CLEAR FAULT REPORTS?NoRange: No, Yes CLEAR EVENT RECORDS?NoRange: No, Yes CLEAR OSCILLOGRAPHY?NoRange: No, Yes CLEAR DATA LOGGER?NoRange: No, Yes CLEAR BREAKER 1ARCING AMPS? NoRange: No, Yes CLEAR BREAKER 2ARCING AMPS? NoRange: No, Yes CLEAR DEMANDRECORDS? NoRange: No, Yes CLEAR ENERGY?NoRange: No, Yes CLEAR UNAUTHORIZEDACCESS? NoRange: No, Yes CLEAR DIRECT I/OCOUNTERS? NoRange: No, Yes.Valid only for units with Direct Input/Output module. CLEAR TELEPROTECTCOUNTERS? NoRange: No, Yes CLEAR IEC61850 XWSI OPCNTSee below CLEAR IEC61850 XCBR OPCNTSee below CLEAR ALL RELAYRECORDS? NoRange: No, Yes
