7TAKEOFF TOUR190-00357-00 Rev GFuel On Board and ChecklistsThe Instrument Panel Self-Test Page includes selec-tions to set fuel on board (FOB) to full capacity andaccess the Checklists Page. This allows you to quicklyset fuel to full limits and display any checklists you’veentered, such as start up or takeoff checklists.To set fuel on board to full (if not provided bysensor):1. Turn the large right knob to highlight “SetFull Fuel?”.Select “Set Full Fuel?” to set fuel on board(FOB) to full capacity.2. Press ENT and verify that fuel on board (FOB)now matches the fuel capacity (CAP) figure.Fuel on board is now reduced, over time, basedon the fuel flow (FF) figure.To view the checklists page:1. Turn the large right knob to highlight “Go ToChecklists?” and press ENT.2. Turn the large right knob to select the desiredchecklist, then follow the steps in Section 9 AuxPages - Utility Page (Checklists) to execute eachstep in the selected checklist.Select “Go To Checklists?” to display theChecklist Page and any available checklists. A500W-series unit can hold up to nine check-lists with up to 30 entries in each checklist.3. Once you complete the desired checklist(s),press the small right knob to return to theChecklists Page. Press the small right knobagain to return to normal operation on theSatellite Status or Map pages.Once you’ve verified instrument operation withthe Instrument Panel Self-Test Page displayed, turnthe large right knob to highlight “OK?” and pressthe ENT key.The Satellite Status Page appears as the 500W-series unit begins to collect satellite information. An“Acquiring” status is displayed on the Satellite StatusPage and the signal strength of any satellites receivedappears as “bar graph” readings. This is a good indica-tion that you are receiving signals and that a positionfix is determined. Following the first-time use of your500W-series unit, the time required for a position fixvaries — usually within two minutes.Fuel On Board and Checklists
